Lenovo 2.5IN 5300 960GB MS SATA SSD 4XB7A17089

ThinkSystem 2.5" 5300 960GB Mainstream SATA 6Gb Hot Swap SSD

The 5300 Mainstream SATA SSDs have the following features:

Industry standard 2.5-inch or 3.5-inch form factors

New generation 96-layer 3D TLC NAND flash memory

Suitable for mixed read/write workloads with an endurance of between 2.5 and 5 drive writes per day (DWPD) for 5 years

6 Gbps SATA host interface

High reliability and enhanced ruggedness

MTTF of 3 million device hours - 50% more than most drives

Absence of moving parts to reduce potential failure points in the server

S.M.A.R.T. support

Advanced Encrypting Standard (AES) 256-bit encryption

SSDs have a huge but finite number of program/erase (P/E) cycles, which affect how long they can perform write operations and thus their life expectancy. Mainstream SSDs typically have a better cost per read IOPS ratio but lower endurance and performance compared to Performance SSDs. SSD write endurance is typically measured by the number of program/erase cycles that the drive can incur over its lifetime, which is listed as total bytes written (TBW) in the device specification.

The TBW value that is assigned to a solid-state device is the total bytes of written data that a drive can be guaranteed to complete. Reaching this limit does not cause the drive to immediately fail; the TBW simply denotes the maximum number of writes that can be guaranteed. A solid-state device does not fail upon reaching the specified TBW. However, at some point after surpassing the TBW value (and based on manufacturing variance margins), the drive reaches the end-of-life point, at which time the drive goes into read-only mode. Because of such behavior, careful planning must be done to use SSDs in the application environments to ensure that the TBW of the drive is not exceeded before the required life expectancy.

Technical Specifications